[3d print] Groundable Europlug for macbook charger

sup guys. i'm reo.



recently, I purchased a MacBook Air.
I found out that there was a ground problem.

I looked up a lot of products to ground it. but It was expensive for me.
so I decided to make it using a 3d printer.


I searched it on thingiverse, and i found this one.

At first, I modified it a little bit.
unfortunately, it didn't fit.

So I cut it in half and made some corrections.

First, a thin aluminum plate is needed.
You can also get it from drinking canned drinks. almost 10cm.

Heat the appropriately cut aluminum plate
and insert it in the front.

or u can do like this

 

 

 

Go through the hole and pull it back.

After attaching it to the duck head with a glue gun,
Cut it to the appropriate length to fit the duct head.
Press it so that it can go inside.

it's done!

thx for watching
have a nc day!

https://www.thingiverse.com/thing:5119211

Groundable Europlug by _Reo